Two Precut Fusible Glass Hangers 90 COE Clear 1x1 inch

These handy hangers fuse right into your project. 

They're easy to use. Just add a little bit of glue to the edge and butt up to your glass. Both must be flat. Fuse as you normally would.

In the illustration, I used two layers of hangers because my project was two layers. 

These would be very difficult to cut by hand. We'll do the cutting. You make the art!

Quantity: Two pieces

Measurements: Squares are 1x1 inch. Inside circle is 1/2 inch.

COE: 90

Glass manufacturer: Bullseye Tekta

Waterjet cut and hand finished in Loveland, Colorado

Safety first! If this glass will be used for an item that will touch food, please make sure to read Bullseye's article on food safety here: www.bullseyeglass.com/wp-content/uploads/Food-Safety.pdf

When working with Frit (particularly Powder Frit), mixing kiln wash powder, or sweeping up glass (and any ensuing dust) it is recommended that you wear a Niosh approved face mask to filter out any fine particulate matter.

⚠ WARNING: This product can expose you to chemicals including lead and/or cadmium, which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.